
You open the blinds on a crisp morning and can barely see the yard. The glass is covered in a gray film of moisture. You grab a towel and wipe the inside, but nothing changes. The fog is on the outside, and you start to wonder whether the new windows you paid for are already failing.
This is not your fault. Fogged glass usually means trouble somewhere, so it’s natural to worry. But when the moisture is on the outside of the glass, window makers say the opposite is true. Andersen states that “Exterior condensation indicates that the glass in the unit has created an effective barrier.” Milgard calls it “a result of the normal functioning of energy efficient windows.”
Table of Contents
Why fog forms on the outside of good windows
Condensation is simple physics. Milgard explains that it forms when moist air comes into contact with cool surfaces such as glass. Andersen points to two factors: higher humidity levels, and an exterior glass surface that falls below the dew point.
Efficient glass makes that second part more likely. Milgard notes that energy-efficient windows significantly reduce the interior heat conducted through the glass, so less warmth from inside reaches the outer pane. Andersen adds that with Low-E glass, the exterior glass surface may be a few degrees cooler than the interior surface. Older windows that conduct more heat can keep the outer pane warmer, which is one reason the fog may be new to you after an upgrade.
When exterior fog shows up
It tends to appear under predictable conditions. According to Andersen and Milgard, watch for:
- A clear night sky. Andersen lists it among the conditions that come before exterior condensation.
- A warm day followed by a cool night. Milgard says this typically happens in spring and fall.
- Still air. Andersen also lists calm conditions.
- High humidity outdoors. More moisture in the air means more water to settle on the glass.
The good news is that it doesn’t last. Andersen says that “exterior condensation usually evaporates throughout the day and will not affect the interior of the home.” There’s nothing to fix, and wiping it off isn’t necessary.
When fog on the glass is a real problem
Where the moisture sits makes all the difference. Milgard separates three kinds of condensation:
Outside the glass is normal for efficient windows, as above. Inside the glass, on the room side, comes from high humidity and low air exchange in the home. Milgard suggests reducing moisture sources, improving ventilation and leaving closed shades up a couple of inches above the sill. Shower steam adds to indoor humidity, which is why it pays to run the bathroom exhaust fan long enough after a shower.
Between the panes is the one to worry about. Milgard says moisture trapped between the glass may be due to a failed insulating unit, and that it should be repaired. If you see fog you can’t reach from either side, contact the window manufacturer or installer and check your warranty.
Check which side the fog is on before you worry. Outside means the glass is doing its job. That’s the trick.
WHAT DO YOU THINK?